avrdude: stk500_getsync(): not in sync: resp=0x0

0
195

On a recent build, I was asked what I did during a build to make sure everything ran smoothly. I told them I took a break to write my book, and then I ran a Stk500. The response I got was “You did something that didn’t seem to make sense.

Well, that’s probably cause you don’t know the build you’re on and you don’t have your own stk500.

Well, I think its important to take a break from your build and check things out. It is very easy to run into bugs or problems while your building, and not having a stk500 will prevent you from fixing them. But it is also important to know what your doing when youre in the build and what changes are going to be made to your build.

I did some digging on the stk500 and found that in the most recent version (1.4.3) I had a bug that prevented the stk500 from syncing with the stk500 I built. The build was running on my machine, and the stk500 I built ran fine. However, the stk500 I built on my machine didn’t work at all. I spent about 4 hours on it and finally found a way to get it working again.

So lets take a look at this new stk500 and see what I can do about it. I think it would be beneficial to have a few things that are common to all stk500s.

This is where I think it would be beneficial to have a few things that are common to all stk500s. First, I am sure that in some situations, you could say that they all have a bug in that, but I think the only thing that you can’t fix in your stk500s is your own fault.

I think the only thing that you cant fix in your stk500s is your own fault. I think the biggest thing that I see is that the stk500 requires a certain amount of power to function, in this case 12.5 volts. When you try to set it up with only 12.5 volts, the stk500 wont work. It also wont work at all with any other voltage that is below 12.5 volts.

The answer is that the stk500 won’t work with any other voltage that is below 12.5 volts. The only thing that I can see in your screenshot is the stk500 won’t work with any other voltage that is below 12.5 volts. That’s a very, very small thing, which is why the stk500 is not working with any other voltage that is below 12.5 volts.

I am not sure if this has to do with the stk500 not working at all, but I would check that you power it on to the correct voltage. It may just be a software error, but I would do this before even attempting to set it up.

You’re right, it may have to. But what exactly does this mean? I think it means that when I put my phone on my desk, I get confused and think, “Oh, this is just going to freeze up, so why would I do this? The system will freeze up when I call.” I really do not understand this because I am not sure why the stk500 is not working with any other voltage that is below 12.5 volts.

LEAVE A REPLY

Please enter your comment!
Please enter your name here